Good Afternoon All,
We are getting ready to deploy Embarcadero Data Architect 16.0.2. I looked on Embarcadero's website and see nothing that acts as a deployment or admin guide. The install is a 314 mb single file executable. We deploy software with sccm. There are two license files also which need to be copied over to Program Data\Embarcadero. I ran the install and saw what seems to be a single .msi file which ways in at about 750mb. I would much rather deploy the msi file via sccm as that would also make adding the license files as simple as writing an .mst. When I ran the .msi, which is called erdamsi.msi it runs through to a point where I get the following message:
Could not write value CollectUsageStatistics to key \Software\Embarcadero\ER/Studio Data Architect 16.0\Tools. Verify that you have sufficient access to that key, or contact your support personnel.
Choices Cancel, Retry, Ignore
Cancel rolls back, retry does nothing, and ignore (not sure yet) and yes I am running under admin credentials
Ran erdamsi. from elevated command prompt (as a test) using msiexec /i erdamsi.msi /qb!
